Icom IC-756 Instruction Manual page 62

8
SET MODE
Miscellaneous (others) set mode
The spectrum scope shows the transmit signal wave-
form while transmitting. This can be deactivated if de-
sired.
When "OFF" is selected, the spectrum scope holds
the received waveform while transmitting and does
not show the transmit waveform.
When the optional UT-102
installed, you can select between English and Japan-
ese as the language.
See p. 61 for unit installation.
When the optional UT-102
installed, you can select between faster or slower syn-
thesizer output.
See p. 61 for unit installation.
When the optional UT-102
installed, you can have frequency, mode and signal
level announcement. Signal level announcement can
be deactivated if desired.
When "OFF" is selected, the signal level is not an-
nounced.
See p. 61 for unit installation.
This item sets the number of memo pad channels
available. 5 or 10 memo pads can be set.
This item sets the rate at which frequencies are
scanned when the microphone [UP]/[DN] switches
are pushed and held. High or low can be selected.
59
(continued)
is
VOICE SYNTHESIZER UNIT
is
VOICE SYNTHESIZER UNIT
is
VOICE SYNTHESIZER UNIT
Spectrum scope displays
the transmit waveform
(default)
English announcement
(default)
Faster announcement
(default)
Signal level announcement
(default)
5 memo pads
(default)
High speed (default,
50 tuning steps/sec.)
Spectrum scope does
not display the transmit
waveform
Japanese announcement
Slower announcement
No signal level
announcement
10 memo pads
Low speed
(25 tuning steps/sec.)