Table of Contents
Advertisement
4.2
Recording Custom Message
The SKE-450 comes with three recorded messages (see Table 4-2). Message 1 & 2 can be
changed through the 7780 software; Message 3 can be recorded from the microphone or by
using the 7780 software. Message 1 & 2 are 32 seconds long, and Message 3 is 49 seconds
long.
Message No.
Voice Gender
Message 1
Female
Message 2
Male
Message 3
Female
When in the record mode, the Speaker Trouble and Mic Trouble LEDs will function as
follows:
LED
Speaker Trouble
Mic Trouble
While in record mode, the Message Test Buttons are used as follows:
S1: Replay the recorded message. Message will continue to repeat until the S1 button is
pressed again.
S2: Used to erase message 3. To erase the user message, press S2 until the Speaker Trou-
ble LED turns on. When the Speaker Trouble LED turns off again, the message will be
fully erased.
151267
Table 4-2: Preprogrammed Messages
ATTENTION PLEASE. There has been a report of an emergency.
Proceed calmly to the nearest exit and leave the building immediately.
Do not use the elevators. Use stairwells where necessary. All
handicapped occupants shall use the building's evacuation plan.
We have a fire alarm in our building. Please stay in your apartment and
keep your apartment doors closed; Keep your windows shut and leave
all fire doors closed. Do not use the elevators, and stand by for further
instructions.
ATTENTION PLEASE. The signal tone you have just heard indicates a
report of an event in the building. Please await further instructions
while the report is being verified. If further action is necessary, you will
be instructed to follow floor response plans.
Table 4-3
LED Appearance
Solid ON
Erasing user message.
FLASHING
Recording user message.
OFF
Normal mode (not recording)
ON
Flash is programmed with user message.
OFF
Flash is erased.
FLASHING
Flash error, need to erase and re-record.
firealarmresources.com
Programming
Message
Meaning
4-3
Advertisement
Table of Contents
