Table of Contents
Advertisement
ETP4860-B1A2 Embedded Power
User Manual
Figure 4-21 Preparing a cord end terminal
(1) Cable
Step 2 Install DC output power cables.
● Connect cables to appropriate load circuit breakers based on the load capacity.
● Do not connect load cables to battery circuit breakers. Otherwise, the power
1.
2.
3.
Figure 4-22 Installing DC output power cables
(1) DC load
----End
Issue 04 (2021-01-05)
CA UTION
system may break down.
Use a flat-head screwdriver (2 mm wide) to push the slider in a wiring hole in
place.
Install a battery cable at the wiring hole.
Remove the screwdriver and ensure that the battery cable is securely installed.
Copyright © Huawei Technologies Co., Ltd.
(2) Cord end terminal
4 Installation
(3) Crimping tool
48
Hide quick links:
Advertisement
Table of Contents
