Table of Contents
Advertisement
ETP4860-B1A2 Embedded Power
User Manual
Figure 4-23 Preparing a cord end terminal
(1) Cable
Step 2 Install the battery cables.
Do not connect battery cables to load circuit breakers. Batteries do not support
current limiting, which may cause battery bulge or failure due to overcharge.
1.
2.
3.
Figure 4-24 Installing battery cables
(1) Battery string
Issue 04 (2021-01-05)
CA UTION
Use a flat-head screwdriver (2 mm wide) to push the slider in a wiring hole in
place.
Install a battery cable at the wiring hole.
Remove the screwdriver and ensure that the battery cable is securely installed.
Copyright © Huawei Technologies Co., Ltd.
(2) Cord end terminal
4 Installation
(3) Crimping tool
50
Hide quick links:
Advertisement
Table of Contents
