NetApp AFF A200 System Documentation page 1421

If the impaired node...
Has not automatically switched
over
Has not automatically switched
over, you attempted switchover
with the
metrocluster
command, and the
switchover
switchover was vetoed
3. Resynchronize the data aggregates by running the
command from the surviving cluster.
controller_A_1::> metrocluster heal -phase aggregates
[Job 130] Job succeeded: Heal Aggregates is successful.
If the healing is vetoed, you have the option of reissuing the
-override-vetoes parameter. If you use this optional parameter, the system overrides any soft vetoes that
prevent the healing operation.
4. Verify that the operation has been completed by using the metrocluster operation show command.
controller_A_1::> metrocluster operation show
Operation: heal-aggregates
State: successful
Start Time: 7/25/2016 18:45:55
End Time: 7/25/2016 18:45:56
Errors: -
5. Check the state of the aggregates by using the
controller_A_1::> storage aggregate show
Aggregate
Status
--------- -------- --------- ----- ------- ------ ----------------
------------
...
aggr_b2 227.1GB
raid_dp, mirrored, normal...
6. Heal the root aggregates by using the
1418
Then...
Perform a planned switchover operation from the healthy node:
metrocluster switchover
Review the veto messages and, if possible, resolve the issue and try
again. If you are unable to resolve the issue, contact technical
support.
Size Available Used% State
227.1GB
metrocluster heal -phase root-aggregates
metrocluster heal -phase aggregates
metrocluster heal
storage aggregate show
#Vols
0% online 0 mcc1-a2
command with the
command.
Nodes
command.
RAID