Triumph TIGER Service Manual page 457

Electrical
M t r.
Starter
Removal
Remove the seat (see page 16-9).
1.
2. Disconnect the battery, negative (black) lead first.
Remove the fuel tank (see
3.
4. Remove the low oil pressure warning light switch
11).
(see page
8-
Ease the boot from the starter lead and then release
5.
the lead nut.
6. - Detach the lead.
Release the bolts securing
7.
crankcase.
kk `^ 11 //
ka
''"''
1. Starter motor
.
2 Bolts
8. Ease the starter motor from'the right hand engine
cover while gently moving the camshaft oil feed pipe
out of the way.
1
7.1 8 .
page 10
10-99).
rin the starter to the
t
/1
Service Manual - Tiger
Inspection
1. Ensure the motor turns freely and without binding.
2. Check the starter 0-ring for damage and
deterioration. Replace as necessary.
Installation
1. Fit the starter motor to the right hand engine cover
ensuring that the 0-ring does not become damaged
during installation.
2. Fit the starter motor bolts, then, whilst holding the
starter motor firmly in position against the engine
cover, tighten the starter motor bolts to 10 Nm.
Starter Motor Installation
3. Refit the lead and secure with the nut. Tighten to
7Nm.
4. Refit the boot.
5. Refit the low oil pressure warning light switch (see
page
8-11).
6. Refit the fuel tank (see page
7 Reconnect the battery, positive (red) lead first.
8. Refit the seat (see page
I/I
10-100).
16-9).
uM
T H