Triumph TIGER Service Manual page 256

Fuel Pump
and Filter
Removal
ote.
®
The fuel pump and filter assembly is a
sealed for life unit and must be replaced as a
complete assembly.
1. Remove the seat (see page
2. Disconnect the batte
3. Remove the fuel tank (see page
4. Drain the fuel tank into a suitable container.
Observe the warning advice given in the general
. _ information section on the safe handling of fuel and fuel
w
containers.
A fire, causing personal injury and damage to property,
could result from spilled fuel or fuel not handled or
stored correctly.
5. Invert the fuel tank and place on a protective surface
to prevent paint damage.
6. Remove the fixings securing the fuel pump
mounting plate to the tank. Remove the plate.
0
ceha
1. Fuel pump
2. Mounting plate
3. Mounting plate fixings
7.
Lift the fuel pump and filter assembly and
manoeuvre it from the fuel tank aperture.
Twu
MW
r
Assembly
16-9).
ry , negative (black) lead first.
10-99).
1
2
Service Manual - Tiger
imi
Disconnect the fuel level sensor elect rical connector
8.
and remove the fuel pump and filter assembly.
`^--
U
0
ri
1. Fuel level sensor elect cal connector
Noting its orientation, remove and discard the
9.
sealing ring from the fuel pump assembly.
arch
Fuel Pump and Filter Assembly
Assembly
1. Install a new sealing ring into the fuel pump
assembly, with the seal lip facing uppermost, and
ensure that it is correctly seated.
ri
1.Sealing ng
2. Seal lip
i
P'
1
10.101