Triumph TIGER Service Manual page 218

WTi
iiii I
Fault Code
P0335
';T T
Test
Check terminal and cable integrity:
1
- ECM pin A9
-ECM pin Al
2 Check cable for short circuit:
- ECM pin A9 to earth
- ECM pin Al to earth
3 Check cable continuity:
- ECM pin Al to sensor pin 1
- ECM pin A9 to sensor pin 2
4 Check cable for short circuit:
- ECM pin A9 to ECM pin Al
5 Check crank toothed wheel:
- Damage to teeth - magnetic debris
contamination
6 Reconnect harness, clear fault code and run
engine to verify fault cleared
Circuit Diagram
UMW
I2iiA
Possible cause
Crankshaft sensor system fault
Result
OK
Faulty
OK
Short circuit
OK
Open circuit
OK
Short circuit
OK
Faulty
OK
Fault still present
Crankshaft
Engine
Sensor
Control Module
1 UP At
2 UB A9
Service Manual - Tiger
Action
View & note diagnostic tool 'freeze
frame' data if available.
Ensure sensor is fitted correctly and
connector is secure.
Disconnect ECM and proceed to
pinpoint test 1:
Action
Disconnect sensor and proceed to
test 2
Rectify fault, proceed to test 6
Proceed to test 3
Locate and rectify wiring fault, proceed to test
6
Proceed to test 4
Locate and rectify wiring fault, proceed to test
6
Renew crankshaft sensor, proceed to test 6
Locate and rectify wiring fault, proceed to test
6
Proceed to test 6
Clean/renew toothed wheel, proceed to test 6
Action complete - quit test
Contact Triumph service
iiti
10.63