Triumph TIGER Service Manual page 270

9. Using the throttle adjusters, make adjustments until
the word 'BALANCED' appears
1. Adjusters
10. When balanced, stop the engine and disconnect
diagnostic tool.
11. Refit the airbox (see page 10- 106).
(see page
12. Refit the fuel tank
13. Refit the seat (see page
1. Remove the seat (see page 16-9).
battery,
2. Disconnect the negative
3. Remove the fuel tank (see page 10-99).
airbox
4. Remove the (see
5. Remove the throttle body assembly (see page 10-
113).
6. Remove the throttle position sensor from the left
hand end of the throttle body. Collect the 0-ring on
disassembly.
1. Throttle position sensor
TMUMBH
ii
the
10-100).
16-9).
(black)
lead first.
page
10-104).
Service Manual - Tiger
Installation
1. Fit
the replacement throttle position sensor ensuring
the 0-ring is positioned correctly between the sensor
and throttle body.
Engage the new screws and washers supplied and
2.
part tighten such that the
3. Position the throttle body assembly near to its -fitted
position and reconnect the sensor.
4. Reconnect the battery, positive (red) lead first.
5. Attach the Triumph service diagnostic tool to the
dedicated plug.
6. Turn the ignition to the ON' position.
7. Connect . the diagnostic
and select the 'ADJ UST TUNE'
8. At the next screen, align the cursor with 'THROTTLE
POT RENEW' (see below) then press the validation
key which is marked'*'.
pressing validation
9. On the
will send a command, which
throttle to the fully closed position. The tool will also
display the voltage reading coming from the throttle
position sensor.
10. Gently rotate the new throttle position sensor until
the voltage reading on the tool shows 0.6 volts +
Note:
• This is a setting voltage only. Because of the
adaptive nature of the engine management
system, in-service voltage may vary from
this setting figure.
11. Tighten the sensor retaining screw to 3.5 Nm and
recheck the voltage reading shown on the tool.
Repeat the adjustment if the reading is outside the
specified range.
sensor
can still be rotated.
tool
and scroll through to,
option.
key, the diagnostic tool
drives
the primary
1
- 0 . 0 2 v o l t s .
10.115