Triumph TIGER Service Manual page 456

8. To remove the rotor, prevent the crankshaft from
rotating using tool
T3880375,
centre bolt from the left hand end of the crankshaft.
1. Rotor
2. Tool
T3880375
9. With the rotor bolt removed, insert tool T3880203
to the centre of the alternator.
10. Tighten tool T3880203, while preventing the
crankshaft from turning with tool
release the taper seating of the rotor from the
crankshaft.
1. Rotor
2. Tool T3880375
3. Tool T3880203
11. Withdraw the rotor and tool as an assembly and then
separate the tool from the rotor.
TRJUMM
Assembly
and remove the
1.
Assemble the rotor to the keyway on the crankshaft.
2.
Refit tool T3880375 to prevent the crankshaft from
rotating.
3. Tighten the rotor retaining bolt to 105 Nm.
1.Rotor
2. Tool T3880375
to
T3880375,
4. Remove tool T3880375.
5. Locate the stator to the engine cover.
b. Apply silcone sealer to the cable grommet and align
the cable to the exit slot.
7 Fit the cable retainer bracket and tighten the retainer
bolt to 12 Nm.
8. Tighten the stator bolts to 12 Nm.
9.
Refit the left hand engine cover incorporating a new
gasket. Tighten the cover fixings to 9 Nm.
10. Reconnect the battery positive (red) lead first.
11. Refit the seat (see page 16-9).
Service Manual - Tiger
17.17