Chapter 5 Selecting Points For Status And Control; Introduction; In This Chapter - Simplex InfoAlarm 4100U Operator's Manual

Many of the advanced operations that can be accomplished from the operator interface require you

Introduction

first select the point on which you want to perform the operation. Points can be selected in one of
two ways.
•
•
Refer to the page number listed in this table for information on a specific topic.

In this Chapter

Selecting Points for Status and Control
Alarm, Trouble, Supervisory List. Points that are reporting an alarm, trouble, or
supervisory condition can be selected from the active alarm, trouble, or supervisory list.
Using the Entry Keys. The entry keys, located on the far right of the operator interface,
contain abbreviated labels for each category of point. For example, the key in the upper left
corner of the entry keys is labeled "ZONE" and the key to its right is labeled "SIG." Pressing
one of these keys causes the system to prompt you to select a specific point within the selected
category.
Selecting Points from Alarm, Trouble, Supervisory List
Selecting Points with the Entry Keypad
firealarmresources.com
Chapter 5
Topic
5-1
See Page #
5-2
5-3