Table of Contents
Advertisement
Acknowledging Supervisory Conditions,
Invidivually
If individual acknowledge is enabled on your system, you need to separately acknowledge each
Acknowleding
supervisory condition. Use the following procedure to do this.
Supervisory
1.
Conditions
2.
3.
When the problem causing the condition is corrected, the SUPERVISORY LED flashes and the
tone-alert sounds steady.
4.
5.
Unlock and open the enclosure door. The display shows the supervisory condition, similar to
Figure 4-1.
Press the SUPV ACK key. Repeat this step and read the reports. The display shows the area
and type of condition. The tone-alert silences and the yellow LED glows steady.
Read the display. Investigate the problem to determine its cause.
Press the SUPV ACK key. The display shows the system status.
Press the SUPV ACK key again. After a short delay, the display indicates that the system is
normal.
firealarmresources.com
continued
4-4
Advertisement
Table of Contents
