Install Driver For Computer Connection; Operating Systems - Campbell GRANITE VOLT Series Product Manual

After installing a field station, wait around long enough to confirm that good measurements are
being made, that data are collected to the GRANITE data logger, and that data from the
GRANITE data loggercan be collected to a computer.

9.1 Install driver for computer connection

9.2 Operating systems
9.3 Configuring VOLT 100 series
9.4 Data logger programming
9.5 Data logger connection
9.6 Connecting multiple GRANITE Measurement Modules
9.7 Power connection
9.8 Earth ground connection
9.9 Mounting in an enclosure
9.1 Install driver for computer connection
Installing the VOLT 100 series may require a connection to a computer. Install the device driver
before plugging the VOLT 100 series into your computer for the first time. You will need the
device driver properly installed before you can connect to the VOLT 100 series via USB.
SURVEYOR automatically installs the required drivers. To install the device driver using the Device
Configuration Utility, select GRANITE > VOLT 100 series. Click the Install the USB driver link and
follow the prompts.
TIP:
Driver installation is optional for computers running Windows 10 and later.

9.2 Operating systems

Campbell Scientific posts OS updates at
available. Before deploying instruments, check operating system versions and update as needed
to the most recent version. Use the Device Configuration Utility and follow the procedures on the
Send OS tab.
NOTE:
For best performance, use the most recent operating system for each device.
www.campbellsci.com/downloads
22
22
23
25
26
26
28
29
29
when they become
VOLT 100 series 22