F" Group: Main Profile Parameters - Hitachi CP-X200 Instruction Manual

"F" Group: Main Profile Parameters

The basic frequency (speed) profile is
defined by parameters contained in the "F"
Group as shown to the right. The set
running frequency is in Hz, but acceleration
and deceleration are specified in the time
duration of the ramp (from zero to
maximum frequency, or from maximum
frequency to zero). The motor direction
parameter determines whether the keypad
Run key produces a FWD or REV command.
This parameter
intelligent terminal
functions, which you configure separately.
Acceleration 1 and Deceleration 1 are the standard default accel and decel values for the
main profile. Accel and decel values for an alternative profile are specified by using
parameters Ax92 through Ax93. The motor direction selection (F004) determines the
direction of rotation as commanded only from the keypad. This setting applies to any
motor profile (1st or 2nd) in use at t particular time.
Func. Name /
Code SRW Display
F001 Output frequency setting
VR
F002 Acceleration (1) time setting
ACC 1
F202 Acceleration (1) time setting,
2nd motor
2ACC 1
F003 Deceleration (1) time setting
DEC 1
F203 Deceleration (1) time setting,
2nd motor
2DEC 1
F004 Cumulative power-on time
monitor
DIG-RUN
does not affect
[FW] and [REV]
"D" Function
Standard default target
frequency that determines
constant motor speed, range is
0000.0Hz
0.0 / start frequency to 400 Hz
Standard default acceleration,
range is 0.01 to 3000 sec.
010.00s
Standard default acceleration,
2nd motor
range is 0.01 to 3000 sec.
010.00s
Standard default deceleration,
range is 0.01 to 3000 sec.
010.00s
Standard default deceleration,
2nd motor
range is 0.01 to 3000 sec.
010.00s
Two options; select codes:
00 Forward
01 Reverse
FWD
Output
F002
frequency
F001
0
the
Description
3 − 9
3 9
F003
t
Defaults
Run
Mode -FE -FU
Units
Edit
(EU) (USA)
0.0 0.0 Hz
10.0 10.0 sec.
10.0 10.0 sec.
10.0 10.0 sec.
10.0 10.0 sec.
00 00