Hitachi CP-X200 Instruction Manual page 280

Func.
Name
Code
C044 PID deviation level
setting
C052 PID FBV function high
limit
C053 PID FBV function
variable low limit
C070 Selection of OPE /
ModBus
C071 Communication speed
selection
C072 Node allocation
C074 Communication parity
selection
C075 Communication stop bit
selection
C076 Communication error
select
C077 Communication error
time-out
C078 Communication wait
time
C081 O input span calibration
C082 OI input span calibration R/W Scale factor between the external
C086 AM offset calibration
C091 Debug mode enable
C101 Up/Down memory mode
selection
List of Holding Registers
R/W Description
R/W Sets the allowable PID loop error
magnitude (absolute value), SP-PV,
range is 0.0 to 100%, resolution is
0.1%
R/W When the PV exceeds this value,
the PID loop turns OFF the PID
second stage output, range is 0.0 to
100%
R/W When the PV goes below this value,
the PID loop turns ON the PID
second stage output, range is 0.0 to
100%
R/W Two option codes:
02 OPE or option
03 ModBus (485)
NOTE: These network settings are
not accessible to ModBus. Use the
inverter keypad or digital operator
to edit. Refer to "Network
Communication Settings" on page
3–60.
R/W Scale factor between the external
frequency command on terminals
L–O (voltage input) and the
frequency output,
range is 0.0 to 200%
frequency command on terminals
L–OI (voltage input) and the
frequency output,
range is 0.0 to 200%
R/W Offset adjustment of AM output.
Range is 0.0 to 10.0
Adjust together with B080 (AM
gain adjustment)
Displays debug parameters.
Two option codes:
00 Disable
01 Enable
Controls speed setpoint for the
inverter after power sycle.
Two option codes:
00 Clear last frequency (return to
default frequency F001)
01 Keep last frequency adjusted
by UP/DWN
B − 37
B 37
Network Data
Reg. Range Res.
1129h 0 to 1000 0.1 %
112Eh 0 to 1000 0.1 %
112Fh 0 to 1000 0.1 %
1137h 2, 3
1138h
1139h
113Bh
113Ch
113Dh
113Eh
113Fh
1141h 0 to 2000 0.1 %
1142h 0 to 2000 0.1 %
1145h 0 to 100 0.1 V
1149h 0, 1