Hitachi CP-X200 Instruction Manual page 140

Low Load Detection Parameters
The following
conjunction with the intelligent output
function, when configured. The output
mode parameter (C038) sets the mode of
the detection at which the low load
detection signal [LOC] turns ON. Three
kinds of modes can be selected. The
detection level parameter (C039) is to set
the level of the low load.
This function is for generating an early
warning logic output, without causing
either a trip event or a restriction of the
motor current (those effects are available
on other functions).
Func. Name /
Code SRW Display
C038 Output mode of low load
detection signal
LOC MODE
C039 Low load detection level
LOC LVL
parameters work
"C" Function
Three option codes:
00 Disabled
01 During acceleration, deceleration
and constant speed
02 During constant speed only
CRT
Set the level of low load detection,
range is 0.0 to 2.0*inverter rated
02.60A
current
in
Output
current
C039
0
[LOC]
output
1
0
Description
3 − 57
3 57
t
t
Run Defaults
Mode
-FE -FU
Units
Edit
(EU) (USA)
01 01
INV INV A
rated rated
curr. curr.