Hitachi CP-X200 Instruction Manual page 137

3 − 54
3 54
Output Terminal Configuration
The inverter provides configuration for logic (discrete) and analog outputs, shown in the
table below.
Func.
Code
C021 Terminal [11] function
OUT-TM 11
C026 Alarm relay terminal
function
OUT-TM RY
C028 AM signal selection
AM-KIND
The output logic conversion is programmable for terminal [11] and the alarm relay
terminal. The open-collector output terminal [11] defaults to normally open (active low),
but you can select normally closed (active high) for the terminal in order to invert the
sense of the logic. You can invert the logical sense of the alarm relay output as well.
Func.
Code
C031 Terminal [11] active
state
O/C-11
C036 Alarm relay active state
O/C-RY
"C" Function
Name /
SRW Display
12 programmable functions available
for logic (discrete) outputs
(see next section)
FA1
12 programmable functions available
for logic (discrete) outputs
(see next section)
AL
Two available functions:
00 motor speed
01 motor current
(see after next section)
F
"C" Function
Name /
SRW Display
Select logic conversion, two option
codes:
00 normally open [NO]
01 normally closed [NC]
NO
Select logic conversion, two option
codes:
00 normally open [NO]
01 normally closed [NC]
NC
Description
Description
Run Defaults
Mode
-FE -FU
Units
Edit (EU) (USA)
01 01
[FA1] [FA1]
05 05
[AL] [AL]
00 00
[freq] [freq]
Run Defaults
Mode -FE -FU
Units
Edit (EU) (USA)
00 00
01 01