Table of Contents
Advertisement
10.1 Setup Komfort 8K Control Module
1.
Set the main ON/OFF rocker switch in the OFF position.
2.
Remove the remote control components from packaging.
3.
Install (3) AAA batteries (included in the components packet) in
the remote control battery bay.
4.
Connect the transformer to an AC power supply.
5.
Connect the fan to the AUX 300 control module FIGURE 9.1
(page 34).
10.2 Initialize the Komfort
8K Control System
1.
Verify the ON/OFF/REMOTE switch is in the REMOTE position. A
green LED will illuminate and blink three times.
2.
Using a small item, such as a paper clip, press and release the
LEARN button located near the ON/OFF/REMOTE switch.
3.
The control module will beep once and illuminate a green LED
for 10 seconds.
4.
While the green LED is blinking, press the POWER button on the
remote control. The control module will emit a double beep to
indicate that the remote is initialized to the control system.control
10.3 Automatic Safety Turn-off
This system will execute an automatic turn OFF command after 8
hours of continuous main burner operation.
10.4 Backup Battery Operation
Figure 10.1, Back-up Battery Connection
Only install backup batteries in power outages only. Do not leave
batteries installed in the backup battery pack.
This appliance will operate on the backup battery pack in a power
outage. The lifespan of the backup batteries depends on various
factors, such as the quality of the batteries, number of ignitions, etc.
There is a cut-out opening located on the control module housing
that holds the black and red wiring connectors for the back-up
battery pack. See FIGURE 10.1
10.5 Control System 7 Day Timeout
•
If your Komfort 8K control system is set to pilot-on-de-
mand ignition with 7 consecutive days without ignition of
the main burner, the pilot will turn off. This is a standard
#SLA-60 R.8 March 2022
safety feature of the Komfort 8K control system.
Once you turn the pilot-on-demand on, the 7 day timer will start. If at
any time during the following 7 days your main burner ignites, it will
reset the timer back to 7 days.
See section 10.8.7 on page 40 for more information about pilot
ignition selection.
How to check if your system is set to pilot-on-demand:
•
The remote control screen will display the snowflake with text
PILOT icon.
To select the preferred pilot ignition:
1.
Press the MENU button to activate the menu.
2.
Using the UP and DOWN arrows, highlight the PILOT icon and
press SELECT.
3.
Use the UP and DOWN arrows to turn the pilot-on-demand ON
or OFF, then press SELECT.
•
A single beep will be emitted from the control module indicating
pilot-on-demand feature has been activated.
•
A double beep will be emitted from the control module
indicating the pilot-on-demand feature has been deactivated.
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
OPERATING INSTRUCTIONS 37
Advertisement
Table of Contents
