Table of Contents
Advertisement
2.4 Safety Barrier Dimensions
WARNING: A barrier designed to reduce the risk of burns from the hot
viewing glass is provided with this appliance and shall be installed for
the protection of children and other at-risk individuals.
If the barrier becomes damaged, the barrier shall be replaced with
Hussong Mfg.'s barriers for this appliance.
Consider the finish material dimensions when planning your
installation. The safety barrier and glass assembly must be removable.
Refer to Figure 4.3, Minimum Non-Combustible Material Dimensions
on page 20.
The optional finishing trim kit assembly, for use only with safety
barrier #SL60-RSF, will allow you to install finishing material up to the
finishing edge. Refer to Section 4.2 Optional Trim Kit Assembly #SL60-
FTK on page 21. The trim assembly must be attached before fireplace
installation.
24
(627mm)
10 SPECIFICATIONS
⁄
19
"
(503mm)
⁄
"
⁄
24
"
(627mm)
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
2.4.1 Safety Barrier Installation
1.
Center the screen front over the glass frame assembly, allowing
the screen front's mounting brackets to fit inside the air
openings.
2.
Align the notched tabs (located on the back) with the slots in the
fireplace. Raise slightly and push back to desired position.
3.
Lower the screen front until the notched tabs are firmly in
position, verifying the depth accommodates finish material.
•
To remove safety screen: lift the screen up and out of slots.
¼
63
"
(1606mm)
SL60-RSF
⁄
67
"
(1722mm)
SL60-CXSF
⁄
68
"
(1729mm)
SL60-BSF
#SLA-60 R.8 March 2022
Advertisement
Table of Contents
