Chicco BebeCare oasys i-Size Manual page 32

WARNING! The child car seat can be fastened
and unfastened with the baby inside; these
procedures could be more difficult due to the
weight of the baby. Be very careful when per-
forming the steps described above.
4.4 CANOPY
The car seat features a protective canopy that
can be adjusted to multiple positions.
To fit it, insert the ends of the canopy in the
relevant fastening devices (Fig. 26) and then
fit the elastic strap through the relevant hooks
(Fig. 27). Fasten the buttons on the back of the
canopy to complete fitting (Fig. 28).
4.5 CLEANING AND STORAGE
HOW TO CLEAN THE PLASTIC AND METAL
PARTS
Clean the plastic and coated metal parts with a
damp cloth only. Never use abrasive detergents
or solvents.
The movable parts of the child Car seat must
not be lubricated.
CLEANING THE FABRIC LINING
The child seat's fabric lining can be removed
and washed by hand or in a washing machine
at 30°C.
To wash it, unfasten the straps, remove the
shoulder straps by opening the snap-buttons
located inside the compartment for storing
the instruction manual (Fig. 29) and pull off
from the straps (Fig. 30). Then remove the
straps from the slots and the lining from the
headrest (Fig. 31). Remove the fabric lining
from the seat starting from the feet position
(Fig. 32), then from the area near the strap
guides (Fig. 33) and finally removing it com-
pletely (Fig. 34).
Follow the steps above in reverse order to fit
the lining again.
WARNING! Fit the straps again correctly and
avoid twisting.
Please refer to the cleaning instructions on
the fabric label, which illustrates the following
washing symbols:
Machine washable at 30°C.
30° C
30° C
Never use abrasive detergents or solvents. Do
not dry the fabric cover within a dryer, let it dry
without squeezing it.
CHECKING THE CONDITION OF THE COM-
PONENTS
It is recommended to regularly check the con-
dition of the following components to make
sure they are not damaged or worn:
• Fabric cover: check that the padding does
not come out from the seams. Check the
condition of the seams: they must always be
intact and undamaged.
• Harness straps: check that the fabric lining is
not frayed or the harness strap worn out in
the parts corresponding to the adjustment
strap, crotch strap, shoulders and harness
adjustment plate.
• Plastic parts: check that the plastic parts are
not worn out, damaged or faded.
WARNING! If the child car seat is damaged,
deformed or excessively worn, it must be re-
placed, as its original safety features may have
been compromised.
STORING THE PRODUCT
When it is not fitted in the car, it is recom-
mended to store the child car seat in a dry
place, away from sources of heat and to pro-
tect it from dust, humidity and direct sunlight.
WARNINGS ELECTRICAL PARTS
• To replace the battery: loosen the screw lo-
cated on the foot of the support leg (Fig. 35),
open the cover (Fig. 36), remove the drained
battery from the compartment, insert the
new battery, the making sure that correct
battery polarity is observed (positive pole
facing upwards) (Fig. 37), refit the cover and
tighten the screw fully.
32
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean