Adjusting The V-Belt - P.Lindberg 9065033 Manual

Lubricate the blade rotor
Lubricate the blade rotor bearings on both sides
using the lubrication nipple. Also after cleaning!
Remove the cover.
•
Wipe clean the lubrication nipple using a cloth.
•
• Set the grease gun on the lubrication nipple and
pump grease into the nipple.
Re-fit the V-belt guard.
•

Adjusting the V-belt

The V-belt connects the engine to the blade rotor. Especially on
new machines and after the V-belt has been replaced, the belt
becomes wider and thus looser. If the V-belt gives more than
10–15 mm when pressing with a thumb. the belt requires re-
tensioning.
1. Switch off the machine and remove the pulley guard.
2. Loosen the four nuts on the engine.
3. Move the engine back to increase the tension of the V-belt or forward to decrease the
tension of the V-belt.
4. Position the engine and pulley in parallel (if required, use a ruler). Loosen the four nuts
on the engine again.
5. Re-fit the pulley guard.
P. Lindberg A/S
Tel.: +45 70212626
24
Sdr. Ringvej 1
6600 Vejen, Denmark
MAN 9065033 EN V1
www.p-lindberg.dk
E-mail: salg@p-lindberg.dk