Erasing Waypoints - Furuno FAR21x7 & BB FAR28x7 Operator's Manual BB FAR28x7 Operator's Manual

5. VIDEO PLOTTER OPERATION
5.12.3

Erasing waypoints

Waypoints may be erased individually or collectively. Note that a waypoint
cannot be erased if it is part of a nav line.
Erasing individual waypoints
1. With the cursor inside the effective display area, roll the wheel to display
"MARK DELETE / EXIT" in the guidance box.
2. Roll the trackball to place the cursor on the waypoint you wish to erase. A
flashing "+" appears on the mark when it is correctly selected.
3. Push the left button or the wheel to erase the waypoint.
4. To erase another waypoint, repeat steps 2 and 3.
5. To finish, push the right button when the guidance reads "MARK DELETE /
EXIT".
Erasing all waypoints
1. Roll the trackball to choose the MENU box at the right side of the screen and
then push the left button.
2. Roll the wheel to choose 5 PLOTTER and then push the wheel or the left
button.
3. Roll the wheel to choose 8 [DATA ERASE] and then push the wheel or the
left button.
1 BACK
2 OWN TRACK
3 TARGET TRACK*
4 MARK ALL ERASE
5 WPT ALL ERASE
6 NAV LINE ALL ERASE
4. Roll the wheel to choose 5 WPT ALL ERASE.
5. Roll the wheel to choose YES and then push the wheel or the left button to
erase all waypoints.
6. Push the right button three times to close the menu.
5-24
[DATA ERASE]
RED/GRN//BLU/YEL/
CYA/MAG/WHT/
30%/50%/80%/ALL
RED/GRN//BLU/YEL/
CYA/MAG/WHT/
30%/50%/80%/ALL
NO/YES
NO/YES
DATA ERASE menu
* Not available on IMO type