Nav Data Display Setup - Furuno NAVNET 1824C Operator's Manual

2. Adjust the Trackball upward or downward to select Decca chain number.
3. Roll the Trackball rightward to show the display below, to enable selection of station
pair.
CHAIN STATION PAIR
▲
01 R-G
▼
S BALTIC
Decca chain and station pair window
4. Adjust the Trackball upward or downward to select station pair (R: red, G: green and P:
purple).
5. Press the ENTER soft key to register your selection.
6. If necessary, you may enter position offset to refine Decca position. Select (CHAIN)
CORRECTION 1 or CORRECTION 2, then press the EDIT soft key. Enter correction
value with the Trackball and alphanumeric keys. Use the +
from plus to minus and vice versa. Press the ENTER soft key or push the ENTER knob.
7. Press the RETURN soft key twice.
8. Press the GENERAL SETUP soft key followed by the NEXT PAGE soft key.
9. Select "DECCA" from "TD DISPLAY" and "TD" from "POSITION DISPLAY."
10. Press the MENU key twice to close the menu.
7.8

Nav Data Display Setup

The nav data display shows various navigation data, fed from a navigator, network
equipment, etc. You may select the data to display and where to display it as follows:
1. Press the MENU key to open the main menu.
2. Press the SYSTEM CONFIGURATION, SYSTEM SETUP, HOT PAGE & NAV DISP
SETUP and NAV DATA DISPLAY SETUP soft keys.
POSITION
1
2 WPT POS 3
STW
4 5
BEARING RANGE
6 7
8 DEPTH 9
Nav data setup screen
7. CUSTOMIZING YOUR UNIT
< − −>
NAV
DATA
EDIT
SOG
COG
TEMP
RETURN
- soft key to switch
7-29