System Configurations - Furuno NAVNET 1824C Operator's Manual

SYSTEM CONFIGURATIONS

All NavNet products incorporate a "network circuit board" to integrate each NavNet product
on board through an optional LAN cable (Ethernet 10BASE-T). Each NavNet product is
assigned an IP address to enable transfer of images between other NavNet products. For
example, video plotter pictures can be transferred to a radar and vice versa. Pictures
received via the NavNet may be adjusted at the receiving end.
The number of display units which may be installed depends on the number of network
sounder connected. For a system incorporating three or more products, a "hub" is required
to process data.
For one network sounder: one radar and three plotters, or four plotters
For two network sounder: one radar and two plotters, or four plotters
Note: NavNet2 equipment cannot be connected to initial version NavNet equipment.
NavNet system (Model 1824C/1834C/1934C/1944C/1954C/1964C)
MODEL
1964C
AIS transponder
: Standard
: Option
: Local supply
NavNet system (Model 1824C/1834C/1934C/1944C/1954C/1964C)
x
Antenna Unit
MODEL MODEL
1954C 1934C
Power Supply Unit
PSU-005
(MODEL 1954C)
Power Supply Unit
PSU-008
(MODEL 1964C)
AIS Interface
IF-1500AIS*
* Not required for AIS
(Built-in)
Transponder FA-150
Rectifier
RU-3423
100/110/115/220/230 VAC
1φ, 50/60 Hz*
*: The power for the power supply unit
and display unit must be drawn from
the same power source.
MODEL
MODEL
1944C
1834C
Display unit
RDP-149
ARPA
ARP-11
Facsimile
Receiver
FAX-30
12 - 24 VDC*
GPS Receiver
GP-320B/330B
MODEL1824C
Weather Station
WS-200
Echo sounder
Navigator
External buzzer
PC
VGA monitor
Remote display
Video equipment
Heading sensor
HUB
AIS RECEIVER
Network
Other NavNet unit
Sounder
(GD-1920C, etc.)
ETR-6/10N
ETR-30N
OR
FA-30