Furuno NAVNET 1824C Operator's Manual page 3

SAFETY INSTRUCTIONS
SAFETY INSTRUCTIONS
WARNING
ELECTRICAL SHOCK HAZARD
Do not open the equipment.
Only qualified personnel
should work inside the
equipment.
Turn off the radar power
switch before servicing the
antenna unit. Post a warn-
ing sign near the switch
indicating it should not be
turned on while the antenna
unit is being serviced.
Prevent the potential risk of
being struck by the rotating
antenna and exposure to
RF radiation hazard.
Wear a safety belt and hard
hat when working on the
antenna unit.
Serious injury or death can
result if someone falls from
the radar antenna mast.
Do not disassemble or modify the
equipment.
Fire, electrical shock or serious injury can
result.
Turn off the power immediately if water
leaks into the equipment or the equip-
ment is emitting smoke or fire.
Continued use of the equipment can cause
fire or electrical shock.
Use the proper fuse.
Fuse rating is shown on the power cable.
Use of a wrong fuse can result in damage
to the equipment.
Keep heater away from equipment.
Heat can alter equipment shape and melt
the power cord, which can cause fire or
electrical shock.
ii
WARNING
Radio Frequency
Radiation Hazard
The radar antenna emits electromagnetic
radio frequency (RF) energy which can be
harmful, particularly to your eyes. Never
look directly into the antenna aperture from
a close distance while the radar is in
operation or expose yourself to the trans-
mitting antenna at a close distance.
Distances at which RF radiation levels of
100 and 10 W/m exist are given in the
2
table below.
Note: If the antenna unit is installed at a
close distance in front of the wheel house,
your administration may require halt of
transmission within a certain sector of
antenna revolution. This is possible - Ask
your FURUNO representative or dealer to
provide this feature.
Distance to
100 W/m
MODEL
point
MODEL
Nil
1824C
MODEL
Nil
1834C
MODEL Worst case
1934C 0.10 m
MODEL
Nil
1944C
0.20 m
MODEL XN-12A
1954C
Nil
XN-13A
0.50 m
XN-12A
MODEL
1964C
0.40 m
XN-13A
Warning Label
A warning label is attached to the
equipment. Do not remove the label.
If the label is missing or damaged,
contact a FURUNO agent or dealer.
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
Distance to
10 W/m
2 2
point
Worst case
0.70 m
Worst case
1.50 m
Worst case
1.70 m
Worst case
1.20 m
Worst case 2.00 m
Worst case 1.40 m
Worst case 5.40 m
Worst case 3.60 m
Name: Warning Label (1)
Type: 86-003-1011-0
Code No.: 100-236-230