Table of Contents
Advertisement
Alarm list, ISOBUS/E-Control
36. Rotation sensor fertil-
iser If the output rollers are
not moving:
If the alarm appears
despite rotation of the
output rollers:
37. Level sensor: seed
If there is seed in the
hopper:
38. Level sensor: fertiliser
If there is fertiliser in the
hopper:
40. Seed spacing
41. Micro-granulate feed
rate
42. Fertiliser feed rate
43. Seeds per second
44. Sowing quality (plant-
ing accuracy)
45. Number of seeds on a
given row
46. Skips
58
The output roller is stuck.
Check the power supply to the output unit.
Check the motor and the cabling to it.
Check what alarm time has been programmed in the menu for alarm levels.
Check the cabling, connectors and connections.
The sensor is not emitting a signal.
Check the seed level in the seed hopper containing the level sensor.
The sensitivity of the sensor has been incorrectly set.
Check the fertiliser level in the fertiliser hopper.
Check that the sensor is not dirty or damp. Wipe it off with a dry cloth.
Check the sensor's cable, contacts and connections.
The sensor may be defective.
The sensitivity of the sensor has been incorrectly set.
The amount of seed/hectare, or the number of mm between seed/hectare deviates by
more than the set value on a given row, or the entire machine. The reference value is
the set value in the programming menu.
The machine's micro-granulate motors are not managing to feed at the desired feed
rate.
Reduce the feed rate or the speed.
Try changing to a roller that feeds a larger amount of micro-granulate.
NB! Changing the roller means the calibration must be done again.
The machine's fertiliser motors are not managing to feed at the desired feed rate.
Reduce the feed rate or the speed.
Try changing to a roller that feeds a larger amount of fertiliser.
NB! Changing the roller means the calibration must be done again.
The amount of seed/hectare, or the number of mm between seed/hectare deviates by
more than the set value on a given row, or the entire machine. The reference value is
the value input in the programming menu.
The planting accuracy is below the set limit.
The amount of seed/hectare deviates by more than the set value on a given row, or the
entire machine. The reference value is the value input in the programming menu.
The number of skips exceeds the programmed value.
903075-en-gb; 07.06.2017
Advertisement
Table of Contents
