Table of Contents
Advertisement
Figure 6.12
If it does not agree with these data, then it will be
highlighted in red.
To open the selected program, press
To delete a saved program, press
6.4.7
Tramlining Compensation
Figure 6.13
Tramlining Compensation is a function that allows you
to vary the feed rate using the tramline program. By
entering a percentage in (A), all rows adjacent to a
tramlining row will receive an increased feed rate, in
accordance with the percentage entered.
Figure 6.14
In the figure above, the arrows indicate, for example,
which rows will be compensated.
903075-en-gb; 07.06.2017
6.5
.
.
Figure 6.15
Every motor on the seed unit, micro-granulate unit and
fertiliser unit must be programmed to the correct motor
output on WS9. All machines are programmed to the
correct machine type at the factory, but new
programming may be required in conjunction with
software updates or WS9 replacement.
A. Seed motors
B. Fertiliser motors
C. Micro-granulate motors
Adjustment
1. Select which unit is to be set using the function
buttons (the symbol goes green).
2. Change the value by pressing the field to be set and
enter a new value in the pop-up window. Settings
must be made in accordance with "15 Motor
outputs".
Row unit settings
A warning will be shown before you enter the
settings menu: Do not change any settings in
this menu if you are the least bit unsure. An
incorrect value could cause a row unit to stop
working.
Two outputs cannot have the same setting. If
they do, this triggers a CAN bus communication
error alarm.
Basic Settings
15
Advertisement
Table of Contents
