Extron electronics Multi-Graphic Processor MGP 464 HD-SDI User Manual page 84

Command/response table for IP SIS commands (continued)
Command
IP setup commands (continued)
Set administrator password
Clear administrator password 24
N A user password cannot be assigned if an administrator password does not exist. Entering a password when the MGP 464 has not been configured yields an E14 error response
from the processor. If the administrator password is cleared (removed), the user password is removed also.
View administrator password
Set user password 14 24
N A user password cannot be assigned if an administrator password does not exist.
Clear user password 24
View user password
Set extended level password 24
Clear extended level password 24
View extended level password
Set read-only security level support 24
PRELIMINARY
ASCII (Telnet) URL Encoded (Web)
(host to processor) (host to processor)
E X3# } X3# |
CA W CA
E } |
• CA W %20 CA
E } |
CA W CA
E X3# } X3# |
CU W CU
E } |
• CU W %20 CU
E } |
CU W CU
E X5! X3# } X5! X3#
, CO W 2%C
E X5! } X5!
, CO W 2%C CO
E X5! } X5!
CO W CO|
E X6^ X6* } X6^ X6*
* EP W %2A
Response
(Processor to host)
X4! ]
Ipa •
]
Ipa •
X4! ]
X4! ]
Ipu •
]
Ipu •
X4! ]
| X5! X4! ]
CO Ipo •
| X5! ]
Ipo •
X4! ]
| X6^ X6* ]
EP Pvo *
Additional description
X3#
Set administrator access password .
X3#
= 4 to 12 alphanumeric characters. The
password is case sensitive. Special characters
(spaces or symbols) are not allowed.
X4!
= password displayed as four asterisks
( **** ).
Clear/remove all passwords (administrator
and user).
X4!
View password level , shown with leading
zeros.
X3#
Set user password (4-12 alphanumeric
characters). The password is case sensitive.
Special characters (spaces or symbols) are not
allowed.
Clear the user password only.
X4!
View password level , shown with leading
zeros.
X3# X5!
Set password for security level .
X5!
= 1 through 10.
X5!
Remove password from security level
X4!
View password level , shown with leading
zeros.
Enable no-password login at security level
X6*
.
X6^
For :
0 = no-password logon disabled
1 = no-passwors logon enabled
X6*
For :
0 = no-password logon is placed one level
below the lowest existing password level (0
through 11).
1 through 11 = no-password logon enabled
at the level specified if an admin. password
exists.
.