Selecting The Video Signal Type; Configuring The Output - Extron electronics Multi-Graphic Processor MGP 464 HD-SDI User Manual

HTML Configuration and Control, cont'd
To change the name of an input,
1.
2.

Selecting the video signal type

Under each input name box is a pull-down menu from which you can select the
video signal type for the input.
Signal type — RGB, YUV-HD, RGBcvS, DVI (MGP 464 DI and
Film mode — To place an input in film mode, which enables 3:2 and 2:2 pulldown,

Configuring the output

In the Output Configuration section of the Scaler I/O Settings screen, you can select
output parameters from the following pull-down menus:
Resolution — Select the resolution at which the image is displayed on the output
Refresh Rate — Select the rate in Hz at which the output screen is refreshed.
Sync Format — Select the output signal type required by the display device.
Polarity — Select the combination of horizontal and vertical synchronization signal
5-6 MGP 464 • HTML Configuration and Control
On the Scaler I/O Settings screen, select and delete the text in the box under
the desired input number.
Enter a name of up to 16 characters for the input. The following characters
may be used:
Symbols: : / – _ + "
Numerals: 0 through 9
Letters: Lowercase a through z, uppercase A through Z
Spaces also can be used.
MGP 464 HD-SDI only), or HD-SDI (MGP 464 HD-SDI
only) are available on inputs 1 through 4 only. YUVi
component video, S-video, and composite video are
available on all inputs.
The virtual inputs (5 through 19) are displayed on the
screen in groups of three, with one drop-down menu for
each set of three inputs.
For each virtual input group,
• If you select YUVi from the menu, all three
inputs in the group are configured together
as one component video input.
• If you select S-Video,Comp, the first (top) two
inputs are configured as S-video and the
third, as composite.
• If you select Comp,Comp,Comp, each input in
the group is configured as composite video.
select the Film Mode check box below or to the right of the signal type menu.
If RGB, YUV-HD, DVI, or HD-SDI is selected as the signal type, this check box
is unavailable.
screen.
Available formats are RGBHV, RGBS, RGsB, YUV bi-level and YUV tri-level.
polarities.