Table of Contents
Advertisement
IP Address Displays Invalid Value
After you complete the initial configuration, if the IP address that appears at the top of the main screen
displays an invalid value, one of the following conditions may exist:
Condition
The unit is configured to obtain an address using DHCP
and no DHCP server is available.
Note: The DHCP client self-assigns an address in the
169.254 class B network and the red network symbol
appears in the status bar on the main screen.
Faulty Ethernet cable connection.
The unit is configured to use a static IP address, but no
IP address has been entered.
Network connection is unavailable.
A red network symbol
the main screen.
Camera Issues
Video from the camera appears in a small window on the main screen of the user interface above the
REDIAL list. If no video from the camera appears, do the following:
•
Ensure that the camera is properly connected to the LifeSize codec as described in
LifeSize
Passport. Only LifeSize Focus and LifeSize Camera 200 are supported with
LifeSize Passport.
•
Verify that the blue LED on the front of the camera is lit and not blinking.
•
From the main screen of the user interface, press
System Menu. Press
the camera is Ready.
Improving a Dim Image
Adjust the HD Camera Brightness preference in User (or Administrator) Preferences : Diagnostics :
High Definition Camera. You can also add a light source to improve the subject's illumination. Read more
at
Room
Configuration.
appears in the status bar on
to access page 2 of the System Information page. Ensure that the status of
Resolution
Verify that the unit is plugged into a network that has a
DHCP server present.
Replace the Ethernet cable with a high quality cable.
Identify and enter the necessary IP information.
Inspect your network connection.
on the LifeSize remote control to access the
LifeSize Passport Installation Guide
Installing
8
Advertisement
Table of Contents
