Advanced Configuration; Load Profiling; Speed Configuration - ETC QuickTouch Preset Handheld User Manual

ETC User Guide
QuickTouch Preset Handheld

Advanced Configuration

You can open the Advanced dialog for any channel, from which the following tabs are available
with their respective functions.
Trims: Allows you to set trims for the motor
•
Load: Provides load information for your motor
•
Speed: Provides speed information for your motor
•
Status: Provides system status and history
•
Statistic: Provides statistical information
•
Diagnostic: Provides diagnostic information
•

Load Profiling

It is highly recommended that you enable load profiling for your motors. This feature allows you to
record a normal profile of what the load should be at any point in the full range of travel, in both
directions. Load profiling then monitors the load during movement and stops movement when
unexpected load conditions occur.
To record these load profiles and subsequently enable load profiling:
1. Select a channel and press the Advanced button.
2. Select the Load tab and press the Learn button.
For standard loads (i.e. scenery or non-electric loads), press the Save button.
•
For loads that change during travel, press the Record button.
•
3. From the Load tab, you can now select the Enable Profiling button (outlined in
selected).
4. You can also change the sensitivity setting per motor, with Maximum having the lowest
tolerance for deviance from the load profile and Low having the greatest tolerance.

Speed Configuration

You can also set the maximum speed of a motor. To set this speed, select a channel and press the
Advanced button. Select the Speed tab and press on the Max Speed field. In the dialog that
appears, enter the maximum speed at which you would like the motor to run.
QuickTouch Preset Handheld
Record the up and down profiles for the load
-
Save the profiles when you are satisfied
-
Close the Learn Load dialog
-
Page 7 of 15
gold when
ETC