ETC Unison Foundry Relay Controller Installation Manual

ETC Installation Guide
Unison Foundry Relay Controller
Overview
The Unison Foundry Relay Controller offers fully-rated 20 A relays to switch
lighting loads on and off. The Relay Controller provides two outputs of
switched power control that can be wired to individual fixtures or used for
zone control. Each output can be configured to a separate DMX address, or
both outputs can be controlled in unison by setting the Relay Controller to
single-channel mode (see
Control connected loads from any DMX control device. Configure the Relay
Controller either remotely via RDM (using a tool like Concert) or locally on
the controller. See
Specifications
Ambient Environment
For indoor use only. Rated for plenum use.
• 0°C to 50°C (32°F to 122°F) operating temperatures in 5%–95%
non-condensing humidity.
Channel Mode
Configure the Relay Controller
Corporate Headquarters
Global Offices London, UK | Rome, IT | Holzkirchen, DE | Paris, FR | Hong Kong

Dubai, UAE | Singapore | New York, NY | Orlando, FL | Los Angeles, CA | Austin, TX
Web etcconnect.com | Support
Contact etcconnect.com/contactETC
Trademark and patent info:
subject to change. ETC intends this document to be provided in its entirety.
7179M2150 Rev A Released 2023-02
page 7
on
Middleton, WI, USA | +1 608 831 4116

support.etcconnect.com
| © 2023 Electronic Theatre Controls, Inc.
etcconnect.com/ip | Product information and specifications
).
page 7
on .