Replacing Electric Defrost Heater - Hussmann Impact F6 Installation And Operation Manual

6-6 SERVICE
Heater
Bracket
Clips to be located 5-6 inches from bracket
Modular Defrost Heater
5. Remove the heater from the face of the
coil. Be sure to save the attachment clips
for the new heater.
6. Install new heater.
7. Reposition fan plenum.
8. Turn on power.
9. Verify that heater is working properly.
REPLACING ELECTRIC DEFROST
HEATER
These full-length heaters are attached to the
front of the coils. They may be accessed by
removing the fan plenums. To replace:
1. Turn off power.
2. Remove wire display racks and bottom
display pans from the entire case.
P/N 0416183C
Coil
Heater
Coil Fin
!
Always disconnect the electrical power
at the main disconnect when servicing
or replacing any electrical component.
This includes, but is not limited to,
such items as fans, heaters, thermo-
stats and lights.
3. Cut the heater from the heater wiring
harness.
Sealant
Clip
Coil Tube
WARNING
Wiring Harness