P/N 0463880_E
2. Apply butyl tape across the bottom joint. Be
sure to extend the tape up the back and front of
the case.
Silicone sealer may be applied around joining
bolts on both sides in bottom shoe but isn't
necessary if neoprene washers are used.
Butyl Tape
INSTALL SPLASHGUARD BRACKETS
Position splashguard brackets to the merchandiser
and level to the floor. Each bracket has a 1
(38 mm) slot at the rear of the bracket where it
attaches to the merchandiser. Tighten screws to
secure the brackets.
Splashguard
Bracket
Screws
CAUTION
!
To avoid leaks, install splashguard brackets
before installing drip piping.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
1
/
in.
2
Leg
OFFSETTING BUMPER
Offsetting the bumper helps to disguise the joint
locations, giving the lineup a smoother look.
1. Locate starter bumper shipped with the left-
end kit.
2. Remove factory
installed bumper by
pulling bumper away
from bumper retain-
er. Be careful not to
lose the internal
joint trim on the
bumper.
3. If not installed, install bumper end caps as
shown below.
Screws
Bumper End Cap
4. Starting at the left end of the line up, install
the bumper starter section first. To install,
a. Position internal joint trims so that the
first is flush to the left-end panel and the
second is centered between the starter bumper
and the full length bumper as shown on the
next page.
Medium Temperature
.
Pull
Upper
Bumper
Internal
Joint Trim
Bumper Retainer
Excel
1-11