Taking Out Of Operation; Dismantling/Disposal - Leibinger Jet 2 Manual

Group 9

9.6 Taking out of operation

Switch off the high performance printer and disconnect from the electricity mains as well as
the connections of any possible additional devices connected. The connection facilities are to
be found on the rear side of the device. Observe the instructions of the individual
devices!
Dangerous material in the machine!
Read the safety leaflets and the regulations on personal safety
equipment!
Remaining ink and solvent must be removed from the device. More detailed information on
this subject matter can be found in the chapter Filter replacement and ink change. The
corresponding safety information leaflets DIN 52900 and the country specific disposal
regulations must be observed!
The device must be cleaned of dirt, ink residue etc. as described in the chapter Cleaning.

9.7 Dismantling/disposal

The LEIBINGER-JET 2 has been developed and built with materials that ensure problem-
free dismantling and disposal. When dismantling, the information in the chapter Taking out
of operation as well as the respective country specific disposal regulations (e.g. for inks and
solvents) must be taken into consideration.
Release 3.00
Equipping/maintenance Page 152
Leibinger-Jet 2 se