Data Interface X2; Transmission Protocol For Operating System Ljos - Leibinger Jet 2 Manual

Table of Contents

Group 5

5.3.2 Data interface X2

The operation of the LEIBINGER-JET 2 is normally done via the LCD touch display. The

RS 232 input on the rear side of the device (9-pole plug, female, interface X2) can be

used as an external data interface for connection to a PC, notebook or host. The

standard baud rate is 38400 Baud.

For older software versions the baud rate can be reduced to 9600 baud with the help of

a special bridge plug. Further more a special plug to increase the transmission rate to

115200 is obtainable on request.

The interface enables the downloading/running of software, of jobs and of graphic

symbols. A special connection cable and the Leibinger LJ-FLASH program is required to

use this function.

Further more this interface can be used via a PC for a comfortable programming of one

or more Leibinger-Jet 2. For this you would need additionally the Leibinger-software Win

Jet.

The programming device that is connected to the LEIBINGER-JET 2 must work with the

following transmission protocol:

! Asynchronous Mode

! 8 bit/character

Figure 6

Release 3.00

Transport/start up

When using a personal computer with RS 232 C interface a

maximum connection cable length of 10 metres should not be

exceeded, with greater transmission distances the use of an RS

422 connection is recommended.

! 1 stop bit

! Parity = no parity, no parity calculation

Page 34

Leibinger-Jet 2 se

Table of Contents