Intended Use; Sources Of Danger - Leibinger Jet 2 Manual

Group 2

2.3 Intended use

The high performance printer LEIBINGER-JET 2 serves exclusively the contact-free marking,
inscribing and coding of surfaces using the continuous ink jet process.
The high performance printer can be used on the most varying materials (e.g. metal,
synthetic material, glass, paper, wood, pressed materials, rubber etc.) with both, smooth as
well as uneven, rough and stepped surfaces.
The intended use of this device also includes the observance of all
instructions in this manual.
Using the installation for other purposes is considered contrary to
its intended use!
For safety reasons conversions and alterations are only admissible
following consultation with the manufacturer. Repairs to the device must
only be carried out with original replacement parts.
The manufacturer shall not be liable for damage resulting from use for
other than the intended purpose or misuse.

2.4 Sources of danger

Protective devices must neither be removed nor put out of operation.
Defects discovered must be rectified immediately.
Mains connection!
The device has no mains switch and must only be connected to a plug
socket in the direct vicinity of the place of setting up!
Installation of the device
The device must be installed in a well ventilated room only and must be
kept away from any source of heat, flame or sparks, e.g. radiant heater,
etc.
Installation of the print head
The operating staff must not be exposed to danger due to the installation
of the device in a production plant. Moving products under the print head
may cause risk of crushing/cutting. The instructions of the machines
directive must be strictly adhered to
Release 3.00
Safety instructions Page 17
Leibinger-Jet 2 se