Outputs Configuration - UGCS SkyHub User Manual

Outputs Configuration

Parameter
BAUD_RATE
DATE_FORMAT
PAYLOAD_ID
SERIAL_DEVICE
TIME_FORMAT
Important: GPS Receiver loads settings from separate config file. See details in
Setup.
Outputs Configuration
GPS Output Configuration
Parameter
[OUTPUT_GPS]
ADDRESS
BAUD_RATE
FREQUENCY_HZ
START_DELAY_S
Copyright © 2019—2022, SPH Engineering
Default
Description
Value
115200 UART baud rate, bps
yyyy/MM/dd Data format in
Payload ID to display value on the
193
UgCS-CPM widget
UgCS SkyHub 2:
/dev/ttymxc1 Device name. Default value depends on
UgCS SkyHub 3: the UgCS SkyHub generation
/dev/ttyAMA3
HH:mm:ss.zzz Time format in
Default
Description
Value
UgCS SkyHub 2:
/dev/ttymxc1 UART serial device. Default value
UgCS SkyHub depends on the UgCS SkyHub
3*: generation
/dev/ttyAMA3
19200 UART baud rate, bps
Frequency of message sending. Only
1 fixed ranges are available: 1, 2, 3, 4, 5
Hz.
45 Start delay, s
102
UgCS SkyHub User Manual
Position Log
Position Log
GPS Receiver
Table 6.29 — GPS Output settings
Revision 6 • February 2022