Preparation; Prerequisites - UGCS SkyHub User Manual

3 • Preparation

Prerequisites

Required desktop software:
• UgCS v4.3 or higher
• UgCS Custom Payload Monitor v3.15.0 or higher
• Putty SSH Client
• WinSCP
Required desktop software for DJI drones:
• DJI Assistant 2 for A3
Enterprize (M300, M600)
Required desktop software for PX4 based drones:
• QGroundControl
Required desktop software for ArduPilot based drones:
• Mission Planner
Required mobile software for DJI drones:
• For DJI A3 / M600 / M600 Pro:
• For DJI M210 / M210 V2 / M300 RTK:
• UgCS for DJI v2.30 or higher
Connect to UgCS SkyHub Using Wi-Fi
Important: It is strongly recommended to switch off a remote controller before any
operations with the UgCS SkyHub Wi-Fi.
After powering on the UgCS SkyHub operates as Wi-Fi access point with following credentials:
• SSID: UgCS-SkyHub-****** (where ****** is the UgCS SkyHub serial number)
• Passphrase: 12341234
One may connect to UgCS SkyHub via SSH protocol (e.g. using PuTTY or WinSCP).
• IP address: 10.1.0.1
• Port: 22
• Username: root
• Password: <empty>
Copyright © 2019—2022, SPH Engineering
3 • Preparation
(referred below as UgCS)
Autopilot, DJI Assistant 2 for Matrice (M210)
DJI GO
DJI Pilot
(referred below as UgCS for DJI)
(referred below as UgCS-CPM)
22
UgCS SkyHub User Manual
or DJI Assistant 2 for
Revision 6 • February 2022