Gas Detector Setup - UGCS SkyHub User Manual

Gas Detector Setup

Gas Detector Setup
There are common gas detector settings in the [GAS_DETECTOR] section. Check whether
minimum and maximum values correspond to your needs:
[GAS_DETECTOR]
MIN_CONCENTRATION_PPM=0
MAX_CONCENTRATION_PPM=1000
These values are used to bound valid gas detector values. When the gas concentration is out
of the limits, the operator will be notified.
Another parameter to be set is the sensor's background value:
[GAS_DETECTOR]
ZERO_LEVEL_PPM=0
The ZERO_LEVEL_PPM value will be subtracted from the gas concentration reported by the
gas detector resulting in the true gas concentration.
Pergam Laser Falcon Setup
1. Set PERGAM_FALCON item to true in [PAYLOADS] section:
[PAYLOADS]
PERGAM_FALCON=true
2. Choose the appropriate SERIAL_DEVICE in the [PERGAM_FALCON] section:
[PERGAM_FALCON]
SERIAL_DEVICE=/dev/ttyUSB0
See Pergam Laser Falcon Configuration
descriptions.
Pergam LMm Setup
1. Set PERGAM_LMM item to true in [PAYLOADS] section:
[PAYLOADS]
PERGAM_LMM=true
Copyright © 2019—2022, SPH Engineering
to find all available settings with default values and
52
UgCS SkyHub User Manual
Revision 6 • February 2022