Table of Contents
Advertisement
Gas Detector Configuration
Gas Detector Configuration
Parameter
[GAS_DETECTOR]
MAX_CONCENTRATION_PPM
MIN_CONCENTRATION_PPM
ZERO_LEVEL_PPM
Pergam Laser Falcon Configuration
Parameter
[PERGAM_FALCON]
FREQUENCY_HZ
SERIAL_DEVICE
Note: The Pergam Laser Falcon measures the methane concentration every 100ms, and a
series of 5 measurements are combined into an average. The average and intermediate
measurements are stored on the Pergam Laser Falcon board and can be sent upon request.
The stored information is updated every 500 ms. The FREQUENCY_HZ parameter only sets
the frequency of requests from SkyHub to the Pergam Laser Falcon, while the Pergam Laser
Falcon continues to work according to its scheme.
Copyright © 2019—2022, SPH Engineering
Default
Description
Value
1000
Max gas concentration, PPM
0
Min gas concentration, PPM
Background gas concentration value to
0
be subtracted, PPM
Default
Description
Value
Measuring frequency, Hz. Available
2
values: 2 Hz, 1 Hz, or lower (see Note
under the table)
UART serial device. The built-in Pergam
/dev/ttyUSB0
Laser Falcon UART adapter is used.
97
UgCS SkyHub User Manual
Table 6.17 — Common gas detector settings
Table 6.18 — Pergam Laser Falcon settings
Revision 6 • February 2022
Advertisement
Table of Contents
