Gps Receiver Configuration; Outputs Configuration - UGCS SkyHub User Manual

GPS Receiver Configuration

Parameter
SERIAL_DEVICE
GPS Receiver Configuration
Parameter
[NANORADAR_MR]
BAUD_RATE
DATE_FORMAT
PAYLOAD_ID
SERIAL_DEVICE
TIME_FORMAT
Important: GPS Receiver loads settings from separate config file. See details in
Setup.

Outputs Configuration

GPS Output Configuration
Parameter
[OUTPUT_GPS]
ADDRESS
BAUD_RATE
FREQUENCY_HZ
Copyright © 2019—2021, SPH Engineering
Default
Description
Value
/dev/ttymxc1 UART serial device
Default
Description
Value
115200 UART baud rate, bps
yyyy/MM/dd Data format in
Payload ID to display value on the
193
UgCS-CPM widget
/dev/ttymxc1 UART serial device
HH:mm:ss.zzz Time format in
Default
Description
Value
/dev/ttymxc1 UART serial device
19200 UART baud rate, bps
Frequency of message sending. Only
1 fixed ranges are available: 1, 2, 3, 4, 5
Hz.
121
UgCS SkyHub User Manual
Table 15.29 — GPS Receiver settings
Position Log
Position Log
GPS Receiver
Table 15.30 — GPS Output settings
Revision 5 • November 2021