SMART Board MX Series Installation And Maintenance Manual page 4

Important information
Do not move or mount the display by connecting rope or wire to its handles. The display is heavy,
l
and failure of the rope, wire or handle could lead to injury.
®
Use only VESA -approved mounts if using a mount other than the one supplied with the display..
l
Disconnect all of the display's power cables from the wall outlet and seek assistance from
l
qualified service personnel if any of the following occur:
The power cable or plug is damaged
o
o Liquid is spilled into the display
o Objects fall into the display
o The display is dropped
o Structural damage, such as cracking, occurs
The display behaves unexpectedly when you follow operating instructions
o
Before inserting or removing an OPS from the display, turn off the display using the switch at the
l
back of the display. See Open Pluggable Slot computer (OPS) disclaimer for more information.
Caution
Turn off the display before cleaning its screen. Otherwise, you may scramble the desktop icons or
l
inadvertently activate applications when you wipe the screen.
Avoid setting up and using the display in an area with excessive levels of dust, humidity, and
l
smoke.
Make sure an electrical socket is near the display and remains easily accessible during use.
l
The display should be used only with European TN and TT power distribution systems.
l
It is not suitable for older, IT-type power distribution systems found in some European countries.
This system (IT-type) is widely used isolated from earth, in some installations in France, with
impedance to earth, at 230/400V, and in Norway, with voltage limiter, neutral not distributed, at
230V line-to-line.
Contact qualified personnel if you're uncertain of the type of power system available where
you're installing the display.
The accessory slot's maximum available power is 60 W. The slot is not a limited power source. To
l
reduce the risk of fire, make sure that accessories connecting to the slot satisfy the fire enclosure
requirements of IEC 62368-1.
smarttech.com/kb/171555 4