Control Panel - Maxx Ice MIM150N Service, Installation, And Instruction Manual

Control Panel

You will find the control panel at the left side of
front panel. This control panel offers four pressure
sensitive buttons and a LCD display screen.
1 ON/ OFF Button. Powers the ice machine.
2 Bin Full Process: When the words of "Bin Full" display, the ice
storage bin is full of ice or something is holding the water
curtain open. The unit will stop working when ice cubes are
taken out of the ice storage bin, releasing the water curtain,
the words of "Bin Full" will flash for 3 minutes. The unit will then
restart and returns to the ice making mode.
3 Making Ice Process: When the words of "Making Ice" display, the unit is working in the Ice
Making mode controlled by a temperature probe on the evaporator and a fixed timer.
4 Harvesting Ice Process: When the words of "Harvesting Ice" di splay, the unit is working in the Ice
Harvest mode controlled by a temperature probe on the evaporator and a fixed timer.
5 Clean Button: When this button is pressed, the unit enters the Cleaning mode. the screen will
display "Cleaning" To stop the Cleaning mode, just press
6 Mode Button: Recommended for service technician only. When this button is pressed, unit
can change from Ice Making mode to Ice Harvest mode or from Ice Harvest mode to Ice
Making mode. You can judge the mode from the displaying contents on the screen.
7 Water Fill Process: When the words of "Water Fill" display, there are three minutes for water inlet
and self-checking After three minutes the ice maker will start to make ice automatically.
OPERATION OF THE CONTROL PANEL:
1. When the unit is plugged in and turn on the power switch. Only
"OFF" displays on the LCD screen.
2. Press the ON/OFF button, the LCD screen lights. If normal, only the
words of "Water Fill" and "3 Min To End" displays on the LCD screen.
The ice maker will start to make ice automatically when the words
of "3 Min To End" changes to "0 Min To End".
Note:
 When the ice machine runs in "Water Fill" process, the control board will check the
condenser probe, evaporator probe and bin full probe function, if one of them defaults, the
exclamation mark will appear and blink on the left bottom corner of the LCD screen. At this
time press "ADJUST" button, the Diagnostics for bin full probe, condenser probe and evaporator
probe will appear on the LCD screen.
3. After three minutes, the ice maker will start to make ice automatically.
The words of "Making Ice" displays on the LCD screen.
4. When the ice machine runs in harvest process, the words of
"Harvesting Ice" displays on the LCD screen.
5. When the ice storage bin is full of ice cubes or there is something
obstructing the bin full probe, the words of "Bin Full" displays on the
LCD screen. The unit stops working.
15
(located at the left side of front panel)
See photos below.
the ON/OFF button.
or