Condenser Cleaning; Control Panel - Maxx Ice MIM452 Service, Installation, And Instruction Manual

Cleaning and Maintenance
The ice machine cleaner contains acids
DO NOT use or mix with any other solvent-based cleaner products
Use rubber gloves to protect hands Carefully read the material safety
instructions on the container of the ice machine cleaner
DISCARD the first batch of ice produced after cleaning.

CONDENSER CLEANING

1 See drawing
2 The air cooled condenser should be
vacuumed once or twice per year to
remove any lint that may have been
drawn into it Using a tool that seems
like a probe to remove any lint from
the condenser fins.
NOTE: Do not touch condenser fins. They
are sharp and can be damaged easily.

Control Panel

You will find the control panel at the left side of the
machine This panel includes the clean button, the
mode button and four LED indicators
OPERATION OF THE CONTROL PANEL:
1 When the unit is plugged in and the power switch
is turned on, the power indicator and the other
three indicator lights are all on
2 After three minutes for water inlet, the ice maker
will start to make ice automatically Only the
power and ice-making indicators will be on
3 During harvest, the harvest indicator light is on
and ice-making indicator off When the ice
storage bin is full, only the ice-full indicator and
power indicator are on
NOTE: During the ice making cycle or harvest mode, the machine cannot enter the clean mode.
Pressing the clean button during the ice-making or harvest mode, it will be ignored. The ice-making
or harvest will continue.
4. When you want to clean the machine, turn off the power switch first, then turn it on again. Press the
Clean button within 3 minutes and the ice maker will start the cleaning mode, with harvest and ice-
making indicators blinking After 30 minutes, the cleaning mode stops and the harvest indicator and
ice-making indicators are on steady If you want to restart the ice-making process after cleaning, turn
OFF the power switch first, then turn on the power switch again and the machine will automatically
go into the ice-making process
5. If you want to interrupt the cleaning mode before it is finished, do not press the Clean button again.
Instead, turn the power switch off This stops the cleaning cycle
6 If the unit is connected to the power supply but no visual indicator lights up when the power switch is
turned on, the fuse in the control panel box may need to be replaced
15
DANGER
WARNING
CAUTION
Condenser
(at the left side of the machine)
Ice-Full
Clean
Ice-Making
Mode
Ice-Harvest
White LED
Green LED
Yellow LED
Red LED