How To Configure An Admin Pin After A Brute Force Attack Or Reset; Setting The Unattended Auto-Lock Clock - iStorage DATASHUR SD Manual

26. How to configure an Admin PIN after a Brute Force attack or Reset

It will be necessary after a Brute Force attack or when the datAshur SD has been reset to configure an Admin PIN before the
drive can be used.
PIN Requirements:
• Must be between 8-64 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
Special Characters:
• The Admin PIN can be configured with the use of one or more 'Special Characters' (SHIFT (
down together), this can be placed once or several times anywhere along your 8-64 digit Admin PIN.
If the datAshur SD has been brute forced or reset, the drive will be in standby state (solid
PIN proceed with the following steps.
1. In standby state (solid
down both SHIFT (
2. Enter New Admin PIN and press KEY ( )
button
3. Re-enter the New Admin PIN and press
KEY ( ) button
Note: When the datAshur SD is in Admin Mode, the
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.

27. Setting the Unattended Auto-Lock Clock

To protect against unauthorised access if the drive is unlocked and unattended, the datAshur SD can be set to
automatically lock after a pre-set amount of time. In its default state, the datAshur SD Unattended Auto Lock time-out
feature is turned off. The Unattended Auto Lock can be set to activate between 5 - 99 minutes.
#22
RED LED), press and hold
) + 1 buttons
RED LED which then fades out to the Idle State (all LEDs off).
LED), press and hold down the SHIFT (
BLUE
RED LED which then fades out to the Idle State. To access the drive contents
Solid
and solid
Blinking
switch to a single
back to blinking
Blinking
change to a solid
Admin PIN was successfully configured.
BLUE LED will remain on and solid for 30 seconds only,
www.istorage-uk.com
) + digit pressed
RED LED). to configure an Admin
RED LED will change to blinking
BLUE LEDs
GREEN and solid BLUE
GREEN LED blink and then
GREEN and solid
GREEN LED and solid BLUE
BLUE LED indicating the
) button for a second - the
GREEN
LEDs will
BLUE LEDs
LED