How To Unlock Datashur Sd With User Pin; Changing The User Pin In User Mode - iStorage DATASHUR SD Manual

Note: When the datAshur SD is in Admin Mode, the
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
14.

How to unlock datAshur SD with User PIN

To unlock with the User PIN, the datAshur SD must first be in Standby State (solid
the SHIFT ( ) button for one second.
1. In a standby state (solid
down both the SHIFT (
2. Enter User PIN and press the KEY ( ) button
15.

Changing the User PIN in User Mode

To change the User PIN, first unlock the datAshur SD with a User PIN as described in section 14. Once the drive is in User
Mode (solid GREEN LED) proceed with the following steps.
1. In User Mode press and hold down
both KEY ( ) + 4
2. Enter New User PIN and press the KEY ( )
button
3. Re-enter New User PIN and press the KEY ( )
button
Important: Changing the User PIN must comply with the 'User PIN Policy' if one has been configured as
described in section 8, which imposes a minimum PIN length and whether a 'Special Character' has to be
used. The administrator can refer to section 10 to check the user PIN restrictions.
RED LED which then fades out to the Idle State (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle State. To access the drive contents
RED LED) Press and hold
) + KEY ( ) buttons
www.istorage-uk.com
BLUE LED will remain on and solid for 30 seconds only,
RED
RED LED switches to all LEDs, RED,
BLUE blinking on and off
RED, GREEN
switch to a solid
was successfully unlocked in User Mode
Solid GREEN
GREEN LED and a solid
Blinking
switch to a single
back to blinking
GREEN LED will rapidly blink three times and
will then change to a solid
indicating a successful User PIN change
) button for a second - the
LED) by pressing and holding down
and BLUE blinking LEDs will
GREEN LED indicating drive
LED will change to a blinking
BLUE LED
GREEN and solid BLUE LEDs will
GREEN LED blink and then
GREEN and solid BLUE
GREEN LED
GREEN &
LEDs
#15