How To Check The Unattended Auto-Lock Clock; Set Read-Only In User Mode - iStorage DATASHUR SD Manual

29. How to check the Unattended Auto-Lock Clock

The Administrator is able to check and determine the length of time set for the unattended auto-lock clock by simply noting
the LED sequence as described on the table at the bottom of this page.
To check the unattended auto-lock, first enter the Admin Mode as described in section 5. Once the drive is in Admin
Mode (solid BLUE LED) proceed with the following steps.
1. In Admin Mode press and hold down
SHIFT ( ) + 5
2. Press the KEY ( ) button and the following happens:
a. All LED's (RED, GREEN
b. Each RED LED blink equates to ten (10) minutes.
c. Every GREEN LED blink equates to one (1) minute.
d. All LED's (RED, GREEN
e. LEDs return to solid
The table below describes the LED behaviour whilst checking the unattended auto-lock, for instance if you have set the drive
to automatically lock after 25 minutes, the
Auto-Lock in minutes
5 minutes
15 minutes
25 minutes
40 minutes
Note: When the datAshur SD is in Admin Mode, the
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.

30. Set Read-Only in User Mode

To set the datAshur SD to Read-Only, first enter the User Mode as described in section 14. Once the drive is in User Mode
(solid GREEN LED) proceed with the following steps.
1. In User Mode, press and hold down both "7 + 6"
buttons.
2. Press KEY ( ) button
#24
& BLUE) become solid for 1 second.
& BLUE) become solid for 1 second.
BLUE
RED LED will blink twice (2) and the
RED LED which then fades out to the Idle State (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle State. To access the drive contents
Solid
and BLUE
GREEN
RED GREEN
0 5 Blinks
1 Blink 5 Blinks
2 Blinks 5 Blinks
4 Blinks 0
BLUE LED will remain on and solid for 30 seconds only,
Solid
GREEN
GREEN
GREEN
as Read-Only
www.istorage-uk.com
BLUE LED will change to blinking
LEDs
LED will blink five (5) times.
) button for a second - the
GREEN LED will change to blinking
and BLUE LEDs
and BLUE LEDs will change to a solid
LED indicating the drive is configured
GREEN