How To Configure An Admin Pin After A Brute Force Attack Or Reset; Setting The Unattended Auto-Lock Clock - iStorage DATASHUR PRO2 User Manual

26. How to Configure an Admin PIN after a Brute Force attack or Reset

It will be necessary after a Brute Force attack or when the datAshur PRO
be used.
PIN Requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
If the datAshur PRO has been brute forced or reset, the drive will be in standby state (solid
2
ceed with the following steps.
1. In Standby state (solid RED
down both SHIFT ( ) + 1 buttons
2. Enter New Admin PIN and press KEY ( )
button
3. Re-enter the New Admin PIN and press
KEY ( ) button
Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid RED
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

27. Setting the Unattended Auto-Lock Clock

To protect against unauthorised access if the drive is unlocked and unattended, the datAshur PRO
automatically lock after a pre-set amount of time. In its default state, the datAshur PRO
feature is turned off. The Unattended Auto Lock can be set to activate between 5 - 99 minutes.
LED), press and hold
is in Admin Mode, the BLUE
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
www.istorage-uk.com
has been reset to configure an Admin PIN before the drive can
2
RED
Solid RED LED will change to blinking
solid BLUE LEDs
Blinking GREEN
a single GREEN
GREEN and solid
Blinking GREEN
to BLUE LED rapidly blinking for a few seconds and
then to a solid
was successfully configured.
LED will remain on and solid for 30 seconds only, during which
) button for a second - the solid
Unattended Auto Lock time-out
2
LED). to configure an Admin PIN pro-
GREEN
and solid BLUE LEDs will switch to
LED blink and then back to blinking
BLUE LEDs
LED and solid BLUE LED change
BLUE LED indicating the Admin PIN
BLUE LED switches to a solid
can be set to
2
and
BLUE
2
#23