How To Configure A Self-Destruct Pin - iStorage DATASHUR SD Manual

Note: When the datAshur SD is in Admin Mode, the
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.

23. How to configure a Self-Destruct PIN

Warning: You can configure a self-destruct PIN which when entered performs a Crypto-Erase on the drive
(encryption key is deleted).This process deletes all configured PINs and renders all data stored on the microSD
card as inaccessible (lost forever), the drive will then show as unlocked
another datAshur SD as a backup drive, self-destructing this drive will also render data on other microSD cards
that have been encrypted by this drive as inaccessible and lost forever. Running this feature will cause the
self-destruct PIN to become the new User PIN and the drive will need to be formatted before it can be reused.
To set the Self-Destruct PIN, first enter the Admin Mode as described in section 5. Once the drive is in Admin Mode (solid
BLUE LED) proceed with the following steps.
1. In Admin Mode, press and hold down both
KEY ( ) + 6 buttons
2. Configure a 8-64 digit Self-Destruct PIN and
press the KEY ( ) button
3. Re-enter the Self-Destruct PIN and press
the KEY ( ) button
Note: When the datAshur SD is in Admin Mode, the
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur SD will exit Admin Mode automatically - the solid
BLUE LED switches to a solid
To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
(data), the datAshur SD must first be in the Idle State (all LEDs off) before an Admin/User PIN can be entered.
#20
BLUE
RED LED which then fades out to the Idle State (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle State. To access the drive contents
BLUE
RED LED which then fades out to the Idle State (all LEDs off).
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle State. To access the drive contents
www.istorage-uk.com
LED will remain on and solid for 30 seconds only,
GREEN
Solid BLUE LED will change to blinking
and solid BLUE
Blinking GREEN
switch to a single
back to blinking
GREEN LED will rapidly blink three times before
it changes to a solid
the Self-Destruct PIN has been successfully
configured
LED will remain on and solid for 30 seconds only,
) button for a second - the
LED. Unless you have cloned
GREEN
LEDs
and solid BLUE LEDs will
GREEN LED blink and then
GREEN and solid BLUE LEDs
BLUE LED to indicate
) button for a second - the